Eurorack case 6U/126HP Performer Series


Out of stock

Out of stock

SKU: PSP6U126HP85W Category:


6U/126HP  Performer Series Pro


  • 12mm birchwood fully nailed and glued construction
    Sprayed with a special 2-layer black protective coating
    Flush-mounted rails allow the modules to be mounted even with the sides of the case
    4126HP  rails with M3 threaded inserts
    One 85W MDLR PWR powered busboard (40 power headers in total)
    One MDLR PWR extension board (total of 14 extra headers)
    Total output 85W    4A on 12V, 2.5A on -12V and 1.5 on 5V
    One side-mounted power switches
    One 1.8m power cord
    Power adapter included
    High-quality Penn Elcom components
    Super-comfortable Luxe carrying handle
    Anti-slip rubber feet
    Completely assembled, wired, tested, and ready to play!

Dimensions (L/W/H)

70,5 cm x 32 cm x 17 cm

Total Weight

6.6 kg (includes rails, power supplies, and other hardware)

Module depth

6,9 cm available depth between top of rail and bottom of case
6.2 cm available depth between top of rail and busboard
4.2 cm available depth between top of rail and protection plate PSU part
5.3  cm available depth between top of rail and top of header on busboard


MDLRCASE MDLRPWR powered busboard

MDLRPWR is a high precision low noise and high-powered bus board for your eurorack modular systems. With a total of 40 headers (per busboard) you’ll never run out of connectivity, so all your beloved modules can be easily connected.  MDLR PWR  is universal so it can accept a wide range of mains voltages from 100V to 240V and so this can be used worldwide. MDLR PWR is fed with an external power brick which takes care of no high voltages inside the case.

MDLRPWR 85W Outputs:

Power 85W

+12V / 4A

-12V / 2,5A

+5V / 1.5A


Technical specifications:

Dimensions 420 x 140mm

Height 23mm

Weight 400g


Output stability  ±1% for 0-100% load

Input 18V ( 16V – 20V )

Output Connectors 40 x 16 pin IDC for flat cable

Input connectors WAGO spring terminals + 5.5 / 2.1 DC inlet

Efficiency 92%



Input overvoltage

Input reverse polarity

Output overvoltage

Output short current – automatic recovery

Output overcurrent – automatic recovery

All output protections are independent for each rail


Other Input common-mode LC filter with high efficiency of canceling noise and interference from input connector
Additional input filter on each regulator for minimal output noise and interferences
Shield for reducing RF interferences from regulators
Star distribution topology on PCB
Each “beam” from star topology has 4 headers with noise canceling capacitors.
In star topology center are another noise canceling capacitors
A big ground plane on both sides of PCB
Blue LEDs indicate present and drop of output voltage