Description
6U/126HP Performer Series Pro
Features:
- 12mm birchwood fully nailed and glued construction
Sprayed with a special 2-layer black protective coating
Flush-mounted rails allow the modules to be mounted even with the sides of the case
4126HP rails with M3 threaded inserts
One 85W MDLR PWR powered busboard (40 power headers in total)
One MDLR PWR extension board (total of 14 extra headers)
Total output 85W 4A on 12V, 2.5A on -12V and 1.5 on 5V
One side-mounted power switches
One 1.8m power cord
Power adapter included
High-quality Penn Elcom components
Super-comfortable Luxe carrying handle
Anti-slip rubber feet
Completely assembled, wired, tested, and ready to play!
Dimensions (L/W/H)
70,5 cm x 32 cm x 17 cm
Total Weight
6.6 kg (includes rails, power supplies, and other hardware)
Module depth
6,9 cm available depth between top of rail and bottom of case
6.2 cm available depth between top of rail and busboard
4.2 cm available depth between top of rail and protection plate PSU part
5.3 cm available depth between top of rail and top of header on busboard
MDLRCASE MDLRPWR powered busboard
MDLRPWR is a high precision low noise and high-powered bus board for your eurorack modular systems. With a total of 40 headers (per busboard) you’ll never run out of connectivity, so all your beloved modules can be easily connected. MDLR PWR is universal so it can accept a wide range of mains voltages from 100V to 240V and so this can be used worldwide. MDLR PWR is fed with an external power brick which takes care of no high voltages inside the case.
MDLRPWR 85W Outputs:
Power 85W
+12V / 4A
-12V / 2,5A
+5V / 1.5A
Technical specifications:
Dimensions 420 x 140mm
Height 23mm
Weight 400g
Output stability ±1% for 0-100% load
Input 18V ( 16V – 20V )
Output Connectors 40 x 16 pin IDC for flat cable
Input connectors WAGO spring terminals + 5.5 / 2.1 DC inlet
Efficiency 92%
Protections:
Input overvoltage
Input reverse polarity
Output overvoltage
Output short current – automatic recovery
Output overcurrent – automatic recovery
All output protections are independent for each rail
Other Input common-mode LC filter with high efficiency of canceling noise and interference from input connector
Additional input filter on each regulator for minimal output noise and interferences
Shield for reducing RF interferences from regulators
Star distribution topology on PCB
Each “beam” from star topology has 4 headers with noise canceling capacitors.
In star topology center are another noise canceling capacitors
A big ground plane on both sides of PCB
Blue LEDs indicate present and drop of output voltage
